Ilda / Computer Control - Laserworld Club CS-2000RGB FX Mode D'emploi

The sensitivity can be adjusted between 1 and 100. Standard value is 50.

8.2.6. ILDA / COMPUTER CONTROL

The laser can be used with any laser control software that sup-
ports the ILDA control signal via sub-d connector. Use an ILDA
cable to connect the Digital Analog Converter (DAC / ILDA
interface) of the laser software to the ILDA in port at the laser.
Grating Effects Settings in ILDA mode
To operate the grating effects in ILDA mode the „ILdA" menu must be selected. Press „Enter" to
change the settings.
The standard selection is „L001", which means that the laser will automatically switch through the
grating effects. A certain grating effect can be selected with L002, L003, L004. If L005 is selected
there is no grating effect.
Use the „Up" / „Down" button to change the selection:
Recommended computer control software for your laser:
Showeditor Set with ShowNET
Showcontroller Set with ShowNET
14 / 46
www.showeditor.com
www.showcontroller.com
Laserworld CS-2000RGB FX