Angelo Po 090FT1E Manuel D'utilisation Et D'installation page 46

ELECTRICAL CONNECTION (090FTE-190FTE)
Important
The connection must be made by author-
ised, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials. The ap-
pliance is supplied with operating voltage
400 V/3 N, which can be switched to 230 V/
3 (see next point).
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
IT
GB
DE
ELECTRICAL CONNECTION (091FTE-191FTE)
FR
Important
The connection must be made by author-
ES
ised, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials. The ap-
pliance is supplied with operating voltage
400 V/3 N, which can be switched to 230 V/
3 (see next point).
English
When connecting, take care to connect the
neutral and earth lines.
A
C
D
Before doing any work, cut off the mains elec-
tricity supply.
- 20 -
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
2 - Undo the screws (C) and remove the control
panel (D).
3 - Connect the circuit-breaker (A) to the terminal
board (E) of the appliance as shown in the dia-
gram and in the electrical system diagram at the
back of the manual. Use a flexible cable with at
least type H07RN-F characteristics, rated for an
operating temperature of at least 80°C.
Important
4 - Replace the control panel (D) on completion of
the operation.
C
E
Caution - warning
IDM-39616101500.tif