Angelo Po 090FT1E Manuel D'utilisation Et D'installation page 36

If the safety thermostat is tripped, the appliance has
to be restored to the initial working conditions as fol-
lows.
1 - Undo the screws (B) and remove the control
panel (C).
2 - Press the button (D) of the safety thermostat to
restore the electricity supply.
3 - Replace the control panel (C) on completion of
the operation.
If the safety thermostat is tripped, the appliance has
to be restored to the initial working conditions as fol-
lows.
1 - Press the button (D) of the safety thermo-
stat to restore the electricity supply.
IT
IT
GB GB
To carry out this operation, proceed as follows.
DE DE 1 - Fit the rear frame (A) into the groove provided.
2 - Fit the side frames (B) by inserting the pins into
the slots in the rear frame.
FR FR
ES ES
English
RESETTING THE APPLIANCE (090FTE-190FTE)
RESETTING THE APPLIANCE (091FTE-191FTE)
FITTING THE SPLASH GUARD FRAME
B
B
C
D
D
To clean, remove the splash guard frame and put it
in a dishwasher.
A
B
- 10 -
D
D
IDM-39616100800.tif
IDM-39616102500.tif
IDM-39616100900.tif