SOMFY Sonesse 50 RTS Notice D'installation Et D'utilisation Succincte page 16

EN
2.3.4. Recording the RTS control point
The motorisation is in programming mode:
-- Quickly press the PROG button on the RTS control
point to be programmed:
RTS control point is programmed in the motorisation.
If the motorisation is no longer in programming mode, repeat Step 2.3.1 then perform
Step 2.3.4.
2.3.5. Re-setting the end limits
Readjusting the upper end limit
1) Press the button to bring the motorised
product to the end limit to be readjusted.
V
2) Press the and buttons at the same time
until the motorised product moves up and down.
V
3) Press the or button to move the motorised
product to the new desired position.
button until the motorised product moves up and
down.
Readjusting the lower end limit
V
1) Press the button to bring the motorised
product to the end limit to be readjusted.
V
2) Press the and buttons at the same time
until the motorised product moves up and down.
V
3) Press the or button to move the motorised
product to the new desired position.
button until the motorised product moves up and
down.
16
Images not contractually binding
PROG.
1)
3)
my
1)
3)
my
Copyright © 2014 Somfy SAS. All rights reserved.
2)
4)
2)
4)