Faults And Fault Rectification - Salvis Compactline Série Mode D'emploi

en
7.

Faults and fault rectification

Check any faults in the appliance against the following table:
Malfunction
The green indi­
cator light does
not light when
switched on.
The appliance is
switched on but
does not heat
up.
The built-in fan
is running.
The appliance is
switched on but
does not heat
up.
The built-in fan
does not run.
If you cannot remedy the fault,
‒ switch off the appliance and disconnect from the mains,
‒ do not open the housing,
‒ contact the authorised Customer Service agent.
22 / 48
Possible cause
Main switch before appliance
not turned on.
There is no power supply at
all.
Mains fuse on site has
tripped.
The radiant heating element
is overheated. The overheat­
ing protection on the hob has
shut off the radiant heating el­
ement.
The appliance is overheated.
The bimetal thermostat has
permanently shut off the radi­
ant heating element.
Action
Turn on main switch.
Inform the power supply company.
Possible faults on the appliance must
be checked by an authorised customer
service agent.
Reset the circuit breaker.
Switch off the appliance.
Clean the air filter.
Allow the appliance to cool.
The overheating protection on the radi­
ant heating element reactivates auto­
matically once the radiant heating ele­
ment has cooled sufficiently.
If the fault continues to occur, contact
the authorised customer service.
The appliance can no longer be oper­
ated.
Have the appliance checked by the au­
thorised customer service.