Getting Ready For Use; Overheating Protection; Application Instructions - Salvis Compactline Série Mode D'emploi

4.1

Getting ready for use

. Insert air filter in guide rails.
● CAUTION! The appliance must not be operated without air filter; otherwise risk of malfunctions!
4.2 Switching appliance on
. Place pan or pot on top of the glass ceramic cooking surface.

Overheating protection

● Overheating protection is installed in the hotplates. Thereby, damage is prevented.
● The overheating protection switches the heating element off in the event of insufficient energy
consumption (e.g. there is no cookware on the cooking surface or the cookware is empty).
● Never leave empty cookware on the hotplate.
4.3

Application instructions

● Observe the safety notes, see page 17 section 2.
● For optimum energy transmission, only use cookware and frying ware with level and thick base.
The contact area of the cookware and frying ware must not exceed a diameter of 33 cm. Do not
place the cookware and frying ware on the frame of the cooking area; otherwise poor heat
transfer and damage of the silicon seal.
● Only place cookware and bakeware on the clean glass ceramic cooking surface!
● Immediately remove contamination through salt, seasoning, water and food remains on the cook­
ing hob.
● Place dry cookware on the hotplate. Do not place any wet, steaming saucepan lids on the glass
ceramic cooking surface.
● To keep food warm or to melt fat or butter, use only low power settings.
● Do not reduce the heat by moving the pot but by using the rotary switch.
● If the contents of the saucepan are boiling, turn down to a lower heating level.
● Close pots with lids if the cooking process permits.
● Use high-sided pots for dishes with lots of liquid to prevent them boiling over.
CAUTION! Hot surfaces, hot objects and foods! Hot foods slopping over! Heavy cook­
ware!
Risk of burning! Risk of injury from heavy lifting! Note the weight of the cookware!
. Work with proper back posture!
. Wear protective gloves!
. Use pot holders!
. Exercise appropriate caution!
high power
. Use the rotary switch to switch on the appli­
ance and set the required power level.
● Setting range variable
. After removing the pot or pan, turn the rotary
switch to "0".
en
19 / 48