Playing From Local Media Storage; Playing Media From An Usb Device - Ecler ePLAYER1 Notice D'utilisation

•
FADE: transition mode between audio tracks inside the play queue.
o OFF: transitions without attenuations. Once a track ends completely, the next track in
the playlist starts playing.
o XFADE: cross-fade. Transition between 2 tracks is made by fading out the outgoing
track and fading in the incoming one, mixing both tracks for a short period of time.
Finally, the incoming track reaches its nominal value.
o FADE: the outgoing track fades out to its minimum volume value. After this, the
incoming track fades in until it reaches its nominal value. There is no mixing between
tracks.
•
BOOT MODE: allows player's booting parameters adjustment.
KEEP STATUS: after booting up, it will keep exactly the last configuration it had just before
o
switching off: player status (PLAY/STOP), volume, repeat mode, fade, play mode and playlist.
LOAD PRESET1: preset one will be recalled when the device boots up. This preset is
o
configurable through the web application (see chapter 6).

5.2. Playing from local media storage

5.2.1. Playing media from an USB device

Insert an USB device with compatible audio contents inside the USB port (12). Then, press
ENTER/MENU (6) key to access main menu. In sub-menu SOURCE, rotate CONTROL & SELECT (2)
digital encoder to select USB source and press it to confirm (SELECT). Parameter will blink until
selection is confirmed. Press  (9) to start playing.
If the system cannot find/read the device, the display will show the message: USB
UNAVAILABLE (blinking). If this happens please, check that the device has been inserted properly or
check technical specifications. If audio files are not supported, the display will show the message: NOT
FOUND. If this happen please, check supported audio formats.
A r t i s t - s o n g . m p 3
 0 2 : 5 6
8
ePLAYER1 playing a song from the USB device
U S B