Network; Rj45 Cable Connection; Point-To-Point Wireless Connection - Ecler ePLAYER1 Notice D'utilisation

•
General:
Status: enables or disables full Store & Forward process.
o
Time: time (HH:MM) when synchronization will be executed.
o
•
Remote source:
Host: host or IP Address.
o
Port.
o
Path: host path where contents are stored
o
Username.
o
Private key: private RSA/OPENSSH key
o
•
Local target:
Path: defined by PRESET1 Playlist Path field
o

6.5. Network

This page allows configuring Ethernet (wired) and Wi-Fi interfaces:
•
Wired interface: setup of RJ45 Ethernet interface parameters.
•
Wi-Fi interface: setup of Wi-Fi interface parameters.

6.5.1. RJ45 cable connection

•
Connect RJ45 cable into the Ethernet port (17). IP address will be assigned automatically if DHCP
mode is enabled, so it is not necessary to setup IP settings. If STATIC mode is selected, the following
parameters should be configured:
IP: Internet Protocol address
o
MASK: subnet mask
o
GATEWAY: gateway
o
DNS1: Domain Name System 1
o
DNS2: Domain Name System 2
o

6.5.2. Point-to-point wireless connection

ePLAYER1 can establish a point-to-point wireless connection with a Wi-Fi device (Smartphone,
tablet, PC) to access to the web application or to stream sharing via AirPlay/DLNA
and 5.3.2). Check that the device is configured as an access point or MASTER mode (consult Wi-Fi
settings in the web application).
Open Wi-Fi settings in your device, select ePLAYER1-WI-FI and enter the password:
0123456789. A point-to-point wireless connection will be established.
18
Web application: Wi-Fi interface in master mode
(section 5.3.1