To Pause Recording; Manual Track Division - Teac CD-RW890 Mode D'emploi

Play the source to be recorded and adjust the recording level so
that the loudest sound does not exceed the "OVER" indicator on
the peak level meter.
The level can be adjusted as follows:
MIN. DOWN
∞
– −60 dB
<
When the POWER button or the Stop (
recording level is reset to 0 dB.
<
The volume level differs depending on the source (record, cassette
tape, CD, etc.). To record various sources at the appropriate volume,
the recording level should be adjusted for each source.
6 Press the Play (y) or the Pause (J ) button to start
recording.
Recording starts.
7
Play the source to be recorded.
When the playback of the source has been finished, press the Stop
(H) button to stop recording.
To stop recording
Press the Stop (H) button to stop recording.
<
If the CD-R is finalized, it can be played with another CD player.
UP MAX.
0 dB +12 dB
H) button is pressed, the

To pause recording

Press the Pause (J) button. "WAITING" briefly appears on the
display, then recording is paused.
To restart recording, press the Play (y) button or the Pause (J)
button.
<
You cannot restart recording while "WAITING" is displayed.
<
Remember that every time recording is paused or stopped, a new
track number will always be assigned. It is not possible to record in
two "stages" within one track.
To monitor the input signal
When no recordable disc is loaded in the unit, press the RECORD
button.
"MONITOR" appears on the display, and you can monitor the input
source via the PHONES jack and the output terminals. The meters
show the current input level.
Exit the monitor mode by pressing the Stop (H) button.

Manual track division

It is possible to divide a track into multiple tracks by pressing the
RECORD button while recording.
<
Manual track division is possible regardless of the AUTO/MANUAL
setting.
<
A track cannot be less than 10 seconds in length. The RECORD
button will not work if it is pressed within 10 seconds from the
beginning of a track.
19