Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. TREBLE
This is the knob for setting the treble proportions
(high frequencies) of the sound.
2. BASS
This is the knob for setting the bass proportions
(low frequencies) of the sound.
3. Display window for the tube
4. INPUT: Input Selector
This knob allows you to choose one of the six
inputs.
5. VOLUME: Volume knob
This is the knob for the adjustment of the main
volume level of the system.
6. ANALOG/DIGITAL
Button to choose between analog and digital
inputs. For further information see page 42.
7.
TONE: tone control
If deactivated, audio signals bypass the tone con-
trol that has been set with the dials BASS (2) and
TREBLE (1).
8. Input selection LEDs
The LED that is actually lit shows you which input
channel has been selected. Additionally these
FRONT VIEW
1
2
12
6
7
8
3
4
9
13
10
LEDs show that the appliance is switched on and
not muted.
9. POWER
This is the main power switch for turning on and
off the device. The preamplifier is separated from
the mains voltage when switched off and cannot
be set into a standby state.
10. SPEAKER A/B
With these buttons you can switch on and off the
Speaker Terminal A and B. The LED above shows
which terminal is swithed on.
11. WPS
Button for connection to your wireless network.
12. PHONES
If desired, you can connect a set of headphones
with an impedance between 32
this stereo jack. As long as the headphones are
plugged in, the loudspeakers are switched off.
The volume of the headphone can be changed
with the rotary knob "VOLUME" (5)(26). Before
plugging-in a headphone, the volume setting
should be reduced.
13. Infrared remote control receiver
5
11
and 600
Vincent
to
29
Publicité
Table des Matières
