Dispensing Coffee Drinks With Milk Froth; Dispensing Special Drinks; Dispensing Milk Froth; Dispensing Hot Water - Siemens EQ.500 classic Notice D'utilisation

Dispensing coffee drinks with
milk froth
Requirements
¡ The milk tube is connected.
¡ The suction pipe is connected.
Insert the suction pipe in the milk.
1.
Place your pre-warmed cup under
2.
the outlet system.
Press the symbol for a coffee drink
3.
with milk.
a The display will show the drink and
your current settings.
→ "Drink settings", Page 56
Change the settings where neces-
4.
sary:
Use to adjust the amount.
‒
→ "Adjusting the amount",
Page 56
Use to adjust the coffee
‒
strength.
→ "Adjusting the coffee
strength", Page 56
Use the ground coffee compart-
‒
ment.
→ "Dispensing a coffee drink
made from ground coffee",
Page 54
Press and wait until the process
5.
is complete.
After preparing the drink, the milk
system will automatically clean it-
self with a short jet of steam.
Tip: If you want to stop the dispens-
ing process early, press
want to stop the dispensing process
altogether, press

Dispensing special drinks

Your appliance has other drinks be-
sides the ones that you can obtain
via the quick-selection buttons.
Press several times.
▶
→ "Drinks overview", Page 50
. If you
⁠ .

Dispensing milk froth

WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
Never touch the milk system when
▶
it is hot.
Allow the hot milk system to cool
▶
down before touching it.
Requirements
¡ The milk tube is connected.
¡ The suction pipe is connected.
Insert the suction pipe in the milk,
1.
e.g. Tetra Pak carton.
Place your pre-warmed cup under
2.
the outlet system.
Press repeatedly until the dis-
3.
play shows "Milk froth".
Change the setting if necessary:
4.
Use to adjust the amount.
‒
→ "Adjusting the amount",
Page 56
Press ⁠ .
5.
a The milk froth will run out of the
outlet system.
Press to stop the dispensing
6.
process.

Dispensing hot water

WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
Never touch the milk system when
▶
it is hot.
Allow the hot milk system to cool
▶
down before touching it.
Note: If the milk system has not been
cleaned, small amounts of milk may
be dispensed with the water.
Basic operation en
55