Aventics INTERBUS S Mode D'emploi page 98

98 AVENTICS | INTERBUS S | R412005743–BDL–001–AD
Disassembly and Exchange
3. Attach the (additional) input (5) or output module (4) to the tie
rods (6).
– Make sure the seals (3) have been correctly inserted and
that the contacts have been properly connected.
4. Retighten the E end plate (2) after the last input module (5)
or output module (4) (2 hexagonal head-socket screws
DIN 912 – M4 (1), wrench size 3).
Tightening torque: 2.5 to 3 Nm.
5. Establish the connections (see "Connecting the bus coupler
logic and load supply" on page 75).
6. Adjust the configuration (see "Configuring input/output
modules" on page 88).