Aventics INTERBUS S Mode D'emploi page 73

BUS IN
X71
2 1
3 4
5
BUS OUT
X72
1
2
5
4 3
AVENTICS | INTERBUS S | R412005743–BDL–001–AD
Table 5: Assignment X71 (BUS IN) and X72 (BUS OUT), M12, B-coded
Pin Signal
1 DO
2 /DO
3 DI
4 /DI
5 GND
Fitting Shield
The connection technology and plug assignment comply
with the specifications in the technical guidelines for
INTERBUS S from Phoenix Contact (e.g. IBS SIG part 1 UM
or IBS SYS INST UM installation manual). These have to be
observed.
These settings are made using the switch beneath the PG
fittings A and B (see Fig. 2 on page 66).
Proceed as follows for all of the presettings:
1. Remove the corresponding PG fitting.
2. Adjust the corresponding setting as described below
(see page 74).
3. Refit the PG fitting in its original position. Pay attention that
the sealing rings are positioned correctly.
Meaning
Data line from IBS master
Data line from IBS master inverted
Data line to IBS master
Data line to IBS master inverted
Ground
73
Assembly