Aventics INTERBUS S Mode D'emploi page 83

1)
Examples Subbases used
Example 1 Subbases for double solenoid valves
Example 2 Subbases for double solenoid valves
Example 3 Subbases for double solenoid valves
Example 4 Subbases for single solenoid valves
Example 5 Subbases for double solenoid valves
Combined with
Subbases for single solenoid valves
Example 6 Subbases for double solenoid valves
Combined with
Subbases for single solenoid valves
1)
Other combinations may be selected in accordance with your requirements.
AVENTICS | INTERBUS S | R412005743–BDL–001–AD
Voltage at switches
Switches can be damaged if voltage is applied during operation.
Always operate switches in a voltage-free state!
O
How to assign the valve supply:
1. Open the lower screw cap B (see Fig. 9 on page 82).
2. Using the S4, S5, and S6 switches, assign each valve group
to one of the two supply voltages U
Fig. 9).
Examples for the assignment of the S4, S5 and S6 switches and
the supply of assembled valves for 24 valve output stages can
be found in Tab. 15 and Tab. 16 on pages 84, 85 and for 32 valve
output stages in Tab. 17 and Tab. 18 on pages 86 and 87
(examples 1 to 3/examples 4 to 6, respectively). The following
example combinations are listed there:
From an electrical connection viewpoint, the subbases for
double solenoid valves must come first and then those for
single solenoid valves. The maximum number of solenoids
for all subbases is 24 (R412005748) or 32 (R412008082).
The assignment of switches and valve supplies changes if
module expansions are used (see operating instructions
R412008961) This also applies to the following examples in
Tab. 16 and Tab. 17).
Commissioning and Operation
NOTICE
or U
Q1 Q2
Valve equipment
Double solenoid valves
Single solenoid valves
Single and double solenoid valves
Single solenoid valves
Double solenoid valves
Single solenoid valves
Single and double solenoid valves
Single solenoid valves
83
(see Tab. 14 and