Safety Information - SEFRAM SP297B Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Warning
Safety sheet
Warning
Safety sheet
. . . . . . . . . .
. . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
. . . . . . . .
. . . . . . . . .
 Safety Information
To ensure safe operation and service of the meter,
follow these instructions. Failure to observe
warnings can result in severe INJURY or DEATH.
 Warning
WARNING identifies hazardous conditions and
actions that could cause bodily harm or death.
• If the equipment is used in a manner not speci-
fied by the manufacturer, the protection provided
by the equipment may be impaired.
• Always use proper terminals and range for
measurements.
• To reduce the risk of fire or electric shock, do not
use this product around explosive gas or in damp
locations.
• Verify the Meter operation by measuring a known
voltage. If in doubt, have the Meter serviced.
• Do not apply more than the rated voltage, as
marked on Meter, between terminals or between
any terminal and earth ground.
• To avoid false readings that can lead to electric
shock and injury, replace battery as soon as low
battery indicator appears.
• Avoid working alone so that assistance can be
rendered.
• Do not use the Meter if the Meter is not operating
properly or if it is wet.
• Individual protective device must be used if
hazardous live parts in the installation where the
measurement is to be carried out could be
accessible.
• When using test leads or probes, keep your
fingers behind the finger guards.
• Use caution with voltages above 30 Vac rms,
42 Vac peak, or 60 Vdc. These voltages pose a
shock hazard.
• Remove test lead from Meter before opening the
battery door or Meter case.
• DO NOT USE the test leads when the internal
white insulation layer is exposed.
1
 Read First

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sp298b

Table des Matières