SEFRAM SP297B Notice D'utilisation page 19

• DO NOT USE the test leads above maximum
ratings of CAT. environment, voltage and current,
that are indicated on the probe and the probe tip
guard cap.
• DO NOT USE the test leads without the probe tip
guard cap in CAT III and CAT IV environments.
• Probe assemblies to be used for MAINS meas-
urements shall be RATED as appropriate for
MEAS UREMENT CATEGORY III or IV accord-
ing to IEC 61010-031 and shall have a voltage
RATING of at least the voltage of the circuit to be
measured.
• Disconnect circuit power and discharge all high
voltage capacitors before testing resistance,
continuity, diodes, or capacitance.
• Do not use a flexible current sensor if the inner
copper wire of the insulation of the flexible cord
is visible.
• De-energize the installation under test or wear
suitable protective clothing during fitting and
removal of the Flexible Current Probe.
• Do not apply around or remove from UNINSU-
LATED HAZARDOUS LIVE conductors, which
may render electric shock, electric burn, or arc
flash.
 Caution
CAUTION identifies conditions and actions that
could damage the Meter, the equipment under
test, or cause permanent loss of data.
• Remove the batteries if the Meter is not used for
an extended period of time, or if stored in
temperatures above 50 °C. If the batteries are not
removed, battery leakage can damage the Meter.
• Do not expose Meter to extremes in temperature
of high humidity.
2