Safety Information - SEFRAM MW3027 Notice D'utilisation


Warning 
Safety


. . . . . . . . . .
. . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
. . . . . . . .
. . . . . . . . .



Safety Information

To ensure safe operation and service of the
Tester, follow these instructions.
Failure to observe warnings can result in
severe injury or death.
- Individual protective equipment should be
used if HAZARDOUS LIVE parts in the
installation where measurement is to be
carried out could be ACCESSIBLE.
- If the equipment is used in a manner not
specified by the manufacturer, the
protection provided by the equipment may
be impaired.
- Always use proper terminals, switch
position, and range for measurements.
- To reduce the risk of fire or electric shock,
do not expose this product to rain or
moisture.
- Verify the Meter operation by measuring
a known voltage. If in doubt, have the Meter
serviced.
- Do not apply more than the rated voltage,
as marked on Meter, between terminals or
between any terminal and earth ground.
- To avoid false readings that can lead to
electric shock and injury, replace battery
as soon as low battery indicator.
- Do not use Meter around explosive gas or
vapor.
- When using test leads or probes, keep
your fingers behind the finger guards.
- Remove test lead from Meter before
opening the battery door or Meter case.
- Use caution with voltages above 30 Vac
rms, 42 Vac peak, or 60 Vdc.
These voltages pose a shock hazard.
- Probe assemblies to be used for MAINS
measurements shall be RATED as
appropriate for MEASUREMENT
CATEGORY III or IV according to
IEC 61010-031 and shall have a voltage
RATING of at least the voltage of the circuit
to be measured.
- Do not expose Meter to extremes in
temperature of high humidity.
1
Read First
M MW3027 F 00