Safety Information - SEFRAM MW 3352 Notice D'utilisation

Safety Information

To ensure safe operation and service of
the Meter, follow these instructions.
Failure to observe warnings can result in
severe injury or death.
- Avoid working alone so assistance can
be rendered.
- Do not use test leads or the Clamp
Meter if they look damaged.
- Do not use the Meter if the Clamp Meter
is not operating properly or if it is wet.
- Use the Clamp Meter only as specified
in the Instruction card or the protection
by the Clamp Meter might be impaired.
- Use extreme caution when working
around bare conductors or bus bar.
Contact with the conductor could
result in electric shock.
- Use caution with voltages above 30 V
ac rms, or 60 V dc. These voltages
pose a shock hazard.
Symbols as marked on the
Tester and Instruction card
Risk of electric shock
See instruction card
Equipment protected by double or
reinforced insulation

Battery
Earth
Conforms to EU directives
Caution
If the meter is used in the vicinity of
equipment which generates electromag-
netic interference, the display may
become unstable or the measurements
show may be subject to large errors.
13