Safety Information - SEFRAM MW 3380 Notice D'utilisation

Safety Information

To ensure safe operation and service
of the Meter, follow these instructions.
Failure to observe warnings can result
in severe injury or death.
- Avoid working alone so assistance can
be rendered.
- Do not use test leads or the Meter if
they look damaged.
- Do not use the Meter if the Meter is
not operating properly or if it is wet.
- Use the Meter only as specified in the
Instruction card or the protection by
the Meter might be impaired.
- Use extreme caution when working
around bare conductors or bus bar.
Contact with the conductor could
result in electric shock.
- Use caution with voltages above 30 V
ac rms, or 60 V dc. These voltages
pose a shock hazard.
Symbols as marked on the Tester
and Manual
Risk of electric shock

See instruction card

Equipment protected by double or

reinforced insulation
<
Battery
Earth

Conforms to EU directives

15