Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TOOLS REQUIRED:
8 mm L-Wrench
5 mm L-Wrench / Screwdriver
13/15 mm Flat Wrench
Screwdriver (not included)
ALL
MODELS
PARTS INCLUDED:
1 Stabilizer Tube
1 Guide Rail Set
2 Pedal Arms
1 Manual Incline Set (EX-69 only)
2 Lower Handlebars
2 Upper Handlebars
2 Lower Link Arms With Footpads
1 Top Cap (2 pieces)
1 Console Mast
1 Console Mast Boot
1 Console
2 Handlebar Caps
1 Water Bottle Holder
1 Rear Cover
1 Audio Adapter Cable
1 Power Cord
1 Hardware Kit
10
PRE ASSEMBLY
UNPACKING
Unpack the product where you will be using it. Place the elliptical carton on a level
flat surface. It is recommended that you place a protective covering on your floor.
Never open box when it is on its side.
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place
and partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any
grease, such as lithium bike grease is recommended.
NOTE: It is recommended that two people work together for ease and efficiency
while assembling an elliptical.
NEED HELP?
If you have questions or if
there are any missing parts,
contact Customer Tech
Support. Contact information
is located on the back panel
of this manual.
Publicité
Table des Matières
