Electrical Connections - Wamsler W1-75 Instructions De Montage Et D'utilisation

Important NOTES relevant to operation dependent on air supply from room or inde-
pendent of air supply from room (valid for Germany – as of January 2014):
•
The stoves have been tested under EN 12815 as stoves relying on air supply from
room. The stoves take in all the air required for combustion via the central air intake
from the surrounding room. This intake can have an external enclosed air supply at-
tached to it. Even with this sealed air supply the stoves do not meet the requirements
for operation independent of the air supply from the room.
•
If used in combination with air management systems (e.g. controlled air supply
and evacuation systems, steam extractors or similar) then in Germany Part 4 of Fire
Regulations (FeuVO) apply. These determine among other things, that the stove and
the air management systems must be jointly managed (e.g. using a differential pres-
sure monitor) or an air supply system must be installed, which is approved for use with
solid fuel stoves and which supplies the room where it is installed with sufficient addi-
tional air (approx. 40 m³/h) for the combustion in the fire box.
•
You must always comply – in consultation with the local authority responsible for
approving heating systems – with the local rules and regulations. We cannot accept
any responsibility for changes subsequent to the publication of this instruction manual.
We reserve the right to make changes.
1.6

Electrical connections

The stoves have an electrical connection for the oven light. The connecting cable is at the
back of the oven. This connection must be attached by a trained electrician according to
current standards! It requires a 230V AC current.
View from below
35
Side view