Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Filters - shark Rocket UV425CCO Guide Du Propriétaire

MAINTAINING YOUR VACUUM

CAUTION: Hand
wash filters with
water only to prevent
damage from cleaning
chemicals� Allow
ALL filters to air-dry
completely before
reinstalling them to
prevent liquid from
being drawn into
electric parts�
CAUTION: Turn power
off and unplug before
servicing�
IMPORTANT: Clean the
dust screen inside the
dust cup as required�
NOTE: Empty dust cup
when debris reaches
the MAX fill line�
RECOMMENDED
FILTER CLEANING
SCHEDULE:

EMPTYING THE DUST CUP

Pre-Motor Filter Kit
(Foam & Felt)
1
Press the Wand Release button on the top of the
XPMFK320
wand to disconnect it from the handheld vacuum�
Clean once a month�
Post-Motor Filter
Remove the dust cup from the handheld vacuum
1084FTV320
by squeezing the two Dust Cup Release buttons on
Clean once a year�
both sides of the base at the same time and pulling
it out�
15
1-800-798-7398
STEP 1
Empty
OR
STEP 2
Empty
2
Hold dust cup over a trash bin and
press the Empty button on the front
of the dust cup� The bottom lid will
open, allowing the debris to fall out�
3 Once dust cup is empty, close the
bottom lid and insert dust cup back
into handheld vacuum until you hear
it click into place�
Monthly
Pre-Motor filters
Foam
Felt
Post-Motor filter

CLEANING THE FILTERS

1
Access the pre-motor foam and felt
filters by lifting the latch on the top
of the handheld vacuum� Remove
and rinse the filters with water� Allow
filters to air-dry completely before
reinstalling� Tap loose dirt off filters
between washes as needed� Once
completely dry, insert the felt filter
first, then place the foam filter on
top of it�
2
Access the post-motor filter under
the handle� Remove and rinse the
filter with water� Allow filter to air-
dry completely before reinstalling�
s h a r kc l e a n . c o m
16