Futurelight LIS-69 RGB Mode D'emploi page 31

Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the hole on the bottom of the base Pull the safety bond
over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
DANGER TO LIFE!
31/87
The Moving-Head can be placed
directly on the stage floor or rigged
in any orientation on a truss without
altering its operation characteristics
(see the drawing).
The fixture's base enables to be
mounted in two ways.
For overhead use (mounting height
>100 cm), always
appropriate safety bond.
You must only use safety bonds
complying with DIN 56927, quick
links complying with DIN 56926,
shackles complying with DIN EN
1677-1 and BGV C1 carbines. The
safety bonds, quick links, shackles
and the carbines must be sufficiently
dimensioned and used correctly in
accordance with the latest industrial
safety regulations (e. g. BGV C1,
BGI 810-3).
00031008.DOC, Version 1.0
install an