Scheppach wox d 700sl Mode D'emploi page 39

Commissioning
• Before commissioning the safety.
• All protective and auxiliary devices shall be mounted.
• changeover, adjustment, testing and cleaning work carried out with the engine off. Pull the power plug and wait
stalling of the rotating tool.
• The saw is solely for the cross-sectional cutting of firewood with max. 1 meter length constructed
• Regardless of the timber diameter Only one piece with min. Ø 60 mm are placed on the rocker. In the seesaw of
wox d700sl several logs may be loaded simultaneously, but only so many that the lid can be closed safely
• Functional test before starting work.
• wooden rocker in place.
• pivot the rocker to the saw blade with both hands on the handle.
• Then bring the rocker to the starting position.
• The to be sawn wood may not be fixed by hand.
Petrol engine
(also see Engine Manual)
Starting the engine, Fig. 7
Follow the procedure below for a cold start:
1. Open the fuel valve (B) by turning it to the right to the OPEN
position.
2. Push the choke lever (A) on the engine all the way to the lef
to the ON position.
3. Turn the throttle lever (C) to the left - „FAST position", full
throttle.
4. Recoil start: Hold on tightly to the starter rope handle (D).
Slowly pull on the starter rope handle until you can feel
resstace. Then pull forcefully.
5. When the engine has warmed up, turn the choke lever (A)
right, to the operating position (also see Engine Manual).
6. Note: When restarting a warm engine, the choke is usually
not required. Turn the throttle lever (B) to the FAST posi-
tion.
Let the engine run with the throttle lever in the FAST position.
Tractor mounting
• To grow the circular saw cutting firewood in the longitudinal direction of the 3-point hydraulic system of the tractor.
• The spline stub must be covered with the protective cap.
• The saw must only be operated with the overload clutch. Fig.1 (Included) The Überlastkupplun can accelerate or
retard the speed of development of noise.
• The propeller shaft during operation with the chain secured against spin.
• The propeller shaft after uncoupling from the tractor on the retaining clip.
• When leaving work the tractor-turn and remove the key.
• Use correct PTO shaft. We recommend the scheppach propeller shaft W100 Item No. 05018101.
Abb.2
C
A
B
D
Seite:39