Fault Diagnosis - Truvox International Orbis UHS Cordless Burnisher Manuel D'utilisation

RECOMMENDED SPARES & ACCESSORIES
Replacement 12v 44Ah battery for Orbis Cordless Burnisher (2 required)
Spray System Kit, inc. mounting bracket & tubing.

FAULT DIAGNOSIS

The following simple checks may be performed by the operator. If the machine is still not working, please contact your local Service Agent:
Trouble
No lights illuminated on
charger module
Only red LED on charger
module is illuminated
Yellow LED flashing
Machine not working and
charger indicates the
battery is fully charged
Machine wobbles or
vibrates excessively
*If the fuse blows several times, the machine should be checked by an authorised Service Agent.
PLEASE REFER TO THE BACK OF THE MANUAL FOR PICTORIAL INSTRUCTIONS
4
Reason
Batteries aren't connected
Fault with charger
Battery fault
Battery not connected
Unsuitable battery
Switch interlock incorrectly operated
Current overload fuse blown*
Pad worn or damaged
Dirty pad
Loose pad
Pad is off centre
OCB451500
04-3948-0500
05-4156-0000
Remedy
Connect the batteries
Contact service agent
Contact service agent
Connect battery
Contact service agent
Check operating procedure instructions
Contact service agent
Replace pad
Clean the pad
Tighten pad locking device
Reposition pad
03-20