Explanation Of The Symbols; Multi-Tool Safety - Batavia BT-CMT002 Mode D'emploi

DEAR CUSTOMERS
Instruction manuals provide valuable hints for
using your new device. They enable you to use
all functions, and they help you avoid misun-
derstandings and prevent damage. Please
take the time to read this manual carefully and
keep it for future reference.

EXPLANATION OF THE SYMBOLS

Warning! To reduce the risk of injury,
the user must read the instruction
manual.
Denotes risk of personal injury, loss
of life or damage to the tool in case
of non-observance of the
instructions in this manual.
Always wear hearing protection. The
effects of noise can cause hearing
loss.
Wear safety glasses. When working
with electric power tools, sparks,
splinters, chips and dust particles
may be generated and these can
cause loss of sight.
Electric power tool, protection class
II. This sign symbolises that this unit
corresponds to Protection Class II.
This means that the unit is equipped
with either reinforced or double
insulation between the mains circuit
and output voltage or metal housing
respectively.
CE stands for "Conformité
Européenne", which means "In
accordance with EU Regulations".
With the CE marking, the
manufacturer confirms that this
Electric tool complies with the
applicable European directives.
Do not dispose of electric power
tools with domestic refuse.

MULTI-TOOL SAFETY

General safety advice for multi-purpose hand-
held cordless and corded tools including both
rotating and oscillating types.
7062510-Cordless_Multitool-Ma-#-WoF-1703-30.indb 11
WARNING: Contact with electric or gas lines
can lead to fire, electric shock and explosions.
Penetrating a water line can result in damage
to property and electric shock. Use appropri-
ate detectors to determine if utility lines are
hidden in the work area. Always be extremely
careful when making blind and pocket cuts
where the exit point of the blade or accessory
at the other side of the material cannot be
seen.
WARNING: Asbestos may be in materials and
textured coatings in older properties and
should be treated with extreme caution. If you
suspect or discover asbestos consult your
local health and safety authority immediately
for advice on its removal. It may require the
services of a specialist asbestos removal
company.
WARNING: If a cutting accessory makes con-
tact with a 'live' wire, the exposed metal parts
of the power tool may become 'live' and could
give the operator an electric shock. Hold the
power tool by the insulated gripping surfaces
at all times during use.
WARNING: DO NOT work with damp or wet
materials or accessories that require liquid
coolants. Liquids entering the body of the tool
is an electrical hazard as well as likely to
destroy the tool.
WARNING: The dust produced from working
with some materials can be toxic. Beech, oak,
mahogany and teak natural woods, man-made
composite woods and some surface treat-
ments including paint with lead are toxic. Lead-
based paint is common in buildings pre-1960.
Always wear suitable respiratory protection, for
example, a respirator face mask. Ideally also
use a dust-extraction system or regularly vac-
uum the work area to prevent the build-up of
dust and do a final vacuum after the work is
completed. Most dust is a fire hazard. Over-
head work surfaces have an increased safety
risk for dust.
a. Wear protective, cut-proof gloves when
changing blades and accessories.
Some blades and accessories can be very
sharp. Scraper blades sharpen as they are
used. Blades and accessories shortly after
use can be very hot, allow to cool.
b. Keep your workplace clean. Dusts cre-
ated from different materials including
.
English
11
30-03-17 14:38