Setting The Time; Setting The Calendar - Conrad Electronic WS-8035IT Notice D'emploi

     Setting the time
If no DCF signal can be received (e.g. in a cellar, in case of bad reception conditions or similar), then you can set
the time manually. The quartz clock integrated in the weather station takes over the time display.
Please note: As long as the DCF reception was not switched off, the manually set time will be overwritten at night
in case of a successful signal search (see chapter 9.c).

If not already done, activate the setting mode by pressing the "SET" button, as described in the
beginning of chapter 10.b). The set value for the display contrast flashes. Release the "SET" button.
Briefly press 4x briefly the "SET" button.
The hours of the time display start to flash.
Set the hours by pressing the "OUT/+" button.
Briefly press the "SET " button, the minutes start to flash.
Set the minutes by pressing the "OUT/+" button.
You can set the date by briefly pressing the "SET" button. If no button is actuated for approximately 15 seconds, the
setting mode is quitted; the last setting of the time is saved.
     Setting the calendar
As already described with time setting, also the calendar can be set manually if the DCF signal encounters reception
problems. The basic setting ex works is "01.01.2006" if no DCF reception takes place.
Please note: as long as the DCF reception was not switched off, the manually set calendar will be overwritten at night
in case of a successful signal search (see chapter 9.c).

If not already done, activate the setting mode by pressing the "SET" button, as described in the
beginning of chapter 10.b). The set value for the display contrast flashes. Release the "SET" button.
Briefly press 6x the "SET" button.
The year flashes in the display field next to the moon phase.
Set the year by pressing the "OUT/+" button.
Briefly press the "SET" button, the month starts to flash.
Set the month by pressing the "OUT/+" button.
Briefly press the "SET" button, the date starts to flash.
Set the date by pressing the "OUT/+" button.
You can select the temperature display (°C/°F) by briefly pressing the "SET" button. If no button is actuated for
approximately 15 seconds, the setting mode is quitted; the last setting for the date is saved.
46