ETNA KIF160ZT Mode D'emploi page 72

TROUBLESHOOTING
Symptom
Error code E1/E2.
Error code E3/E4.
Error code E5/E6.
Error code F3 - F8.
Error code F9 - FD.
EN 18
Possible cause
Supply voltage or frequency is
different from the rated values.
Internal temperature of the
hob is too high.
Internal temperature of the
hob is too high.
Error on fan left or right.
Air exhaust blocked, for
example by paper.
Temperature sensor of the
zone defective.
Temperature sensor of the
internal electronics defective.
Solution
Switch off the hob and let
it cool down (H disappears
from the displays). Switch
on the hob. If the same error
is displayed again, call an
authorised service agent.
Switch off the hob and let
it cool down (H disappears
from the displays). Switch
on the hob. If the same error
is displayed again, call an
authorised service agent.
Check that the fan air exhaust
is free. If the error does not
disappear, call an authorised
service agent.
Contact the service
department.
Contact the service
department.