Infant Car Seat - Maxi-Cosi Adorra CV308 Mode D'emploi

WARNING
To avoid serious injury:
• Please refer to the manufacturer's instructions for the use of your infant car seat.
• ALWAYS remove stroller seat before installing car seat.
• ALWAYS install car seat facing to the rear of the stroller (Figure 20).
• ALWAYS use the restraint system in the car seat.
20
To Attach Maxi-Cosi Mico
NOTES:
• Push the parking brake down.
• Remove seat from stroller frame (Reference Step 5 for seat removal).
• Car seat cannot be installed with seat (Figure 20a).
• Car seat not included with models CV308, CV326, CV371, sold separately.
NOTE: Only right side adapter fits into the notch on the right side (Figure 20b).
Align car seat adapters with "ribs" facing inward as shown. Press adapters into slots (Figure 20b),
then slide down until they "click" (Figure 20c).
Car seat must face the handlebar.
"click" (Figures 20d and 20e). Pull up on car seat to be sure it is securely attached.
To remove Mico car seat, press both buttons on car seat (Figure 20e). Lift car seat up.
To remove car seat adapters, push button as shown, then slide upward and remove (Figure 20f).
Notch
20b
To Use
9

Infant Car Seat

®
Lower car seat onto adapters until both sides
20c
OK
20d
NO
20
NO
(Remove seat)
20a
20e
20f