Attach Seat; Bumper Bar - Maxi-Cosi Loola 01401 Mode D'emploi

5

Attach Seat

To attach seat in front or rear facing
position, lower seat into the slots on
each side of the stroller until it clicks
into position (Figure 5). Pull up on seat
to ensure it is attached securely.
To remove, press seat release buttons
on each side (Figure 5a). Lift seat.
6
Canopy
If desired, remove rainshield by unzipping
and removing it from the canopy (Figure 6).
Slide clips into each side of the seat
(Figure 6a). Pull the back of canopy over
the back of the seat.
NOTE: To open canopy, pull canopy
open and press down hinge on each
side. To close, press up on center of
hinges and fold canopy back.
7

Bumper Bar

Press buttons on each side of the seat
and slide bumper bar on until you hear
"click" (Figure 7). Pull to confirm it is
assembled securely.
To remove bumper bar press the buttons
and pull bar off.
Assembly
4
6
5
5a
6a
7