Infant Car Seat - Maxi-Cosi Zelia Mode D'emploi

WARNING
To avoid serious injury:
• Please refer to the manufacturer's instructions for the use of your infant car seat.
• ALWAYS remove stroller seat before installing car seat.
• ALWAYS install car seat facing to the rear of the stroller (Figure 17).
• ALWAYS use the restraint system in the car seat.
17
To Attach Maxi-Cosi Mico
NOTES:
• Push the parking brake down.
• Remove seat from stroller frame (Reference Step 4 for seat removal).
• Car seat cannot be installed with seat (Figure 17).
• Car seat not included with model CV368, sold separately.
NOTE: Only right side adapter fits into the notch on the right side (Figure 17a).
Align car seat adapters with smooth side facing outward as shown. Press adapters into slots
(Figure 17b), then slide down until they "click."
Car seat must face the handlebar.
"click" (Figure 17c). Pull up on car seat to be sure it is securely attached.
To remove Mico 30 infant car seat, press both buttons on car seat (Figure 17d). Lift car seat up.
To remove car seat adapters, push button as shown, then slide upward and remove (Figure 17e).
NO
R L
17a
To Use
9

30 Infant Car Seat

®
Lower car seat onto adapters until both sides
17b
OK
17c
NO
17
17d
17e