Preheating Cups - Nespresso magimix D-150 Mode D'emploi

insert the empty capsule holder into the spout ring,
place a receptacle under the coffee spout and run
the equivalent of one or two large cups of water
by turning the function knob to the
the right. Return the function knob to the «0» posi-
tion. Once the yellow temperature control light
goes off, the machine is ready for use.
Heating liquids (18)
You can also heat liquids thanks to the steam /
hot water nozzle on this machine.
Verify that the function knob is on the «0»
position.
Turn on your machine by pressing the
On/Off Switch to .
Press the steam / hot water switch to the
position. Once the yellow temperature control
light goes off, the machine is ready for use.
Slide the tube of the frothing attachment up
3-5 mm.
Plunge the steam nozzle into the receptacle
containing the liquid to be heated and turn the
position on the left (18).
function knob to the
The yellow temperature control light will go on.
Maintain the end of the nozzle under the sur-
face of the liquid during the entire procedure
ensuring that it does not touch the base of the
receptacle.
Stop the steam by turning the function knob to
the «0» position. The yellow temperature
control light will go off.
Remove the receptacle and pivot the steam
nozzle over the drip tray.
Wipe the steam / hot water nozzle with a
clean damp cloth immediately after its use.
Important: To extract a espresso after having used
the steam, let the machine cool down. To do this,
insert the empty capsule holder in the spout ring,
position on place a receptacle under the coffee spout and run
the equivalent of one or two large cups of water
by turning the function knob to the
the right. . Return the function knob to the «0»
position. Once the yellow temperature control light
goes off, the machine is ready for use.

Preheating Cups

It is highly recommended that you preheat the
cups with very hot water before making the first
espresso of the day. Subsequent cups can be pre-
heated by stocking them on the cup heating plate.
To preheat cups with the steam / hot water
nozzle, follow the instructions given under the
section on: "Preparing Hot Water".
Cleaning (19-21)
After the extraction of each espresso or the
use of the steam / hot water nozzle, residual
water in the thermoblock is discharged into
the drip tray provoking a light hissing noise.
It is therefore necessary to remove the grill
and empty the drip tray (19) after about 20
coffees and, at same time, to clean them with
a non-abrasive, dish washing liquid.
Before reinserting the drip tray and grill,
ensure that the back cover of the drip tray is
properly in place (20).
The capsule holder must be rinsed frequently.
Either run hot tap water through it or simply
insert the empty capsule holder in the spout
ring and let water run through it while slightly
loosening and re-tightening the capsuleholder
position on