Cembre TC04N Notice D'utilisation Et Entretien page 4

ENGLISH
1. GENERAL CHARACTERISTICS
– Application Range: suitable for cutting steel ropes and conductors with max. overall diameter
– Max operating pressure: .............................................................................................. 700 bar (10,000 psi)
– Oil necessary (displacement): ..................................................................................... 61 cm
– Dimensions: length ........................................................................................................ 311 mm (12.2 in.)
width .......................................................................................................... 100 mm (3.9 in.)
– Weight: ................................................................................................................................. 3,9 kg
2. INSTRUCTIONS FOR USE
2.1) Setting
(Ref. to Fig. 4)
The head is equipped with a "self-lock" quick male coupler suitable for connection to a hydraulic,
pneumatic or electric pump from the Cembre range.
– Insert the conductor between the blades at the desired cutting point. For a running conductor,
remove the locking pin (27) and open the tool head.
F F
ULLY RETRACT THE LOWER BLADE ULLY RETRACT THE LOWER BLADE
– With the conductor on the lower blade (12), close the tool head and fully insert the locking pin
(27).
B B
EFORE CARRYING OUT FURTHER CUTTING OPERATIONS MAKE SURE THE LOCKING PIN EFORE CARRYING OUT FURTHER CUTTING OPERATIONS MAKE SURE THE LOCKING PIN
: :
INSERTED INSERTED A PARTIAL INSERTION MAY DAMAGE THE TOOL HEAD A PARTIAL INSERTION MAY DAMAGE THE TOOL HEAD
2.2) Blade advancement
Operate the pump to advance the lower blade.
Make sure the blades are exactly positioned on the desired cutting point; otherwise retract the
lower blade, as § 2.4 and re-position the cutting head.
2.3) Cutting
Continue operating the pump to close the blades and progressively cut the conductor.
2.4) Blade opening
To open the blades, fully discharge the oil pressure from the pump.
HYDRAULIC CUTTING HEAD
of 45 mm (1-25/32"), see TABLE page 22.
(12) (12)
TC04N
BEFORE ATTEMPTING TO OPEN THE TOOL HEAD BEFORE ATTEMPTING TO OPEN THE TOOL HEAD
. .
3 (3.7 cu.in)
(8.6 lbs)
. .
(27) (27)
IS COMPLETELY IS COMPLETELY
4