Table des Matières
Publicité
Operating Instructions
Instructions de service
30.30.01.00413
5.1 Maintenance schedule / Plan d'entretien
Check all load-bearing parts (e.g. suspension) for deformation, wear or
other damage
Check the sealing plates or suction pads for wear, cracks and leaks;
replace if necessary
Check whether the optional filter fleece is dirty
Check whether the optional suction pad filter plate is dirty
General condition of the device
Leak test
When the vacuum generation is running and the smooth, non-
permeable surface of a workpiece (e.g. a metal plate) is fully picked up,
the system vacuum at the vacuum gauge (Fig. 3.1-1 / Point 5) must
indicate a vacuum that is no more than 10% lower than the maximum
possible vacuum of the vacuum generator used. Example: Vacuum
generator reaches max. -0.5 bar. A vacuum between -0.45 and -0.5 bar
must be shown on the gauge
Vacuum test
When the vacuum generation is running and no workpiece is picked up,
the system vacuum at the vacuum gauge must indicate a vacuum
between -0.2 and -0.5 bar. For the area gripper FMP with SVK valve
technology, between -0.35 and -0.5 bar
Visual inspection of the check valves and flow resistors to see whether
they are contaminated
Has the dust filter been cleaned?
Are the vacuum hoses in good condition (not brittle, not kinked, no worn
sections and no leaks)?
Is the type plate still on the device?
Is the operating manual still available and are workers familiar with it?
Clean the sealing plate with a soft brush and a vacuum cleaner, and
remove wood chips, dust, etc. Do not blow off with compressed air.
The force of the stream of compressed air would destroy the structure
of the foam
Check and adjust connections, screws, etc.
Check hose lines and connections for leakage
Note: Suspension, vakuum generators, vacuum hoses and dust filters are not part of the FMP device.
FMP-SVK / FMP-SW
Version 22.01.2014 / Index 2
18
J. Schmalz GmbH
Aacher Straße 29
D - 72293 Glatten
Tél. +49 (0) 7443 / 2403 - 0
Fax +49 (0) 7443 / 2403 - 259
www.schmalz.com
schmalz@schmalz.de
Interval
Daily
Weekly
Monthly
X
X
X
X
X
X
X
X
X
X
X
X
Every six
Annual
months
check
X
X
X
X
X
X
X
X
X
X
X
X
Publicité
Table des Matières
