Location; Power Consumption; Control Panel At A Glance; Remote Control - Trotec B 500 Mode D'emploi

02. Location

The humidifier should be placed on an even surface .
This facilitates circulation and it is advantageousif the
heat source (convector or similar) is located nearby .
Avoid subjecting the humidifier to the effects of out-
side temperatures in excess of + 70°C .

03. Power Consumption

The humidifier is connected to a 230V AC, 50 Hz sock-
et outlet . The power consumption rating is max . 150
VA . It is advisable to protect the electrical supply line
with a 10 Amp fuse . For safety reasons, the power
plug must be disconnected when carrying out all work
on the humidifier .
04. Humidity
The electronic hygrostat (radio-sensor-system) auto-
matically controls the humidifier . The required humid-
ity values can be set by means of the remote control .
m Disconnect the mains plug before opening
the equipment!

05. Control panel at a glance

B 500 Professional
B - 2
1
Receiver sensor for remote control
2
Empty water tank indicator
3 Filter change indicator
4
Electronic water level indicator
5
Fan speed indicator
6 Automatic fan
7
Actual/required atmospheric humidity dis-
play, Menu in programming mode or Fault
code with error message
8
Error message display (note fault code)

06. Remote Control

%
1 Humidity button
The required humidity value can be set with this
button . Pressing + or - several times or holding it
down alters the humidity setting upwards or down-
wards .
2 Fan Taste
Pressing + or – several times increases or
de-creases the fan speed . Other fan speeds can be
selected with the „Automatic" setting (4) .
Operating Manual – Electronic Humidifier
1
2
3
4 5
6
EN