Radio-Sensor-System; Starting Up; Coding The Radio-Sensor-System; Coding The Sensor - Trotec B 500 Mode D'emploi

13. Radio-sensor-system

(Radio frequency 435 MHz)

Starting up

Carefully loosen the underneath of the housing, e .g .
with a screwdriver . Replace the batteries (MN 1500
LR6, 1,5 V AA) .
m Make sure the poles (+/–) are inserted cor-
rectly.
Press the small black test knob
mission function (the green test diode
up) . Please attach it to a dry, well ventilated place
such as a ceiling or a wall and make quite sure it is
not exposed to any direct sunlight . (The calibration is
factoryadjusted to 2%)
14. Coding the radio sensor system

Coding the sensor

These appliances are coded in the factory, but if two
or more are used in direct proximity to one another
(i .e . less than 50 metres apart) a different coding may
be necessary .
B - 6
to check the trans-
1
should light
2
Operating Manual – Electronic Humidifier
For each slide control there are only two positions:
„ON"= up and „0FF" = down, which give 16 possible
combinations . Please note: each appliance and its ra-
dio sensor (a + b) must have the same coding .
You have the option here of controlling a number of ap-
pliances in one room from one sensor, with all of them
a) Device circuit board B 500
b) Radio sensor circuit board
EN