Registering To A Topcom Freeport Base Set - Topcom Butler 1800T Mode D'emploi

Butler 1800T
GAP compatibility does not imply that you can use all base set functions. For example, the base set
might not offer the CLIP (number) display function or it may support another protocol, or it may not
have a compatible callers list (saving incoming calls in memory).
Read carefully the registration procedure of the DECT telephone you already have and follow the
recommended registration procedure to register the BUTLER 1800T to a base set.
3.1.2 Standard Registration Procedure
• Set the base set in registration mode (see your DECT base set manual). This is usually done by
pressing and holding the paging key on the base set until you hear an acoustic signal.
• Press the key 1 time.
• Press the OK key.
• Press the OK key.
• Enter the pin code of your base set (refer to your DECT base set
manual). This code is usually: 0000.
• Press the OK key. The BUTLER 1800T immediately starts
searching for your DECT base set. As soon as it is found, the
display reads the base set identification code.
• Press the OK key to confirm or press the ESC key to cancel your
registration.
• If the phone cannot find the base set, it returns to the initial
display. Repeat the registration procedure.
• If the BUTLER 1800T is registered to a base set, the 'aerial'
symbol appears in the upper right corner of the display. The
internal number of your BUTLER 1800T then appears in the lower
right corner (depends on your DECT base set).
Note:
The BUTLER 1800T phone can be registered to 4 different base sets. The base sets to
which the BUTLER 1800T is registered, are indicated with a

3.2 Registering to a Topcom Freeport Base Set

• Start the Freeport registration mode. To do this, remove your Freeport power supply and connect
it again.
• The aerial LED on your Fre e p o rt starts flashing. Now you have 5 minutes to register your handset.
• Follow the procedure mentioned above and enter PIN code: 1111.
• If the BUTLER 1800T does not find the base set after a few seconds, it returns to the previous
configuration. Try again and check whether your reception zone is interference-free.
Note: The Freeport does not support the unanswered calls list for missed calls.
symbol.
5
M e n u
M oni tor mod e
S e t u p
R e g i s t r a t i o n
R e g i s t r a t i o n
Bas e 1
Ba se 2
Ba se 3
Pin cod e?
SEARCH BAS E 1
B U T L E R 2
R e g i s t r a t i o n
Bas e 1
Ba se 2
Ba se 3