EMAK OM 98L/14,5H Manuel D'utilisation page 66

3.3 FITTING THE SEAT
Mount the seat (1) on the plate (2) using the
screws (3).
2
3
3
1
3.4 ASSEMBLY AND CONNECTING
THE BATTERY
The battery (1) is housed under the seat and
secured by a spring (2).
First connect the red wire (3) to the positive pole
(+) and then the black wire (4) to the negative
pole (–), using the screws supplied as shown.
Apply silicone grease to the terminals and check
that the protective cap for the red wire (8) is in
place.
IMPORTANT
battery according to the instructions in the bat­
tery's manual (
IMPORTANT
device in the electronic circuit board from cut­
ting in, never start the engine until the battery
is fully charged!
1 2
4
WARNING!
chine without the guard (2) or with the bat­
tery incorrectly fixed in its housing.
5
EN 8
4a
2a
2
Always fully charge the
6.2.5).
2b
To prevent the safety
4
5
3
Do not use the ma­
3.5 FITTING THE SIDE DISCHARGE CHUTE
1
From the inside of the chute (1), fit the spring (2)
1
by inserting the terminal (2a) into the hole and
turning it so that both the spring(2) and the termi-
nal (2a) are securely positioned in their seatings.
1
Position the chute (1) in line with the cutting
deck brackets (3). Using a screwdriver, turn the
second terminal (2b) of the spring (2) to bring it
outside the chute.
2
3
1
3
5
4a
Fit the pin (4) in the holes on the brackets (3)
4
and on the chute, so that it passes through the
coils of the spring (2) and the drilled end comes
2
4
out of the inner most bracket.
Fit the cotter pin (5) in the hole (4a) of the pin
(4) and turn the pin until the two ends (5a) of
the split pin can be bend (using pliers), so that it
cannot slip out and let the pin fall out (4).
1 2a
2
2
2b
2a
4
2
3
2b 2
1
3
2
2b
2
3
1 2
2b
1
2
3
5a
1