DESCRIPTION
The Destination
a guiding catheter and an introducer sheath. The sheath is coil
reinforced, has a radiopaque marker and approximately 5 cm
(50 mm) of the distal tip is hydrophilically coated. It comes packaged
with a dilator and choice of hemostatic valve types.
INTENDED USE
The Destination
the introduction of interventional and diagnostic devices into the
human vasculature, including but not limited to the renal arteries.
COMPONENT DESCRIPTION
Refer to product labeling for appropriate system components.
Al components that enter blood vessels are radiopaque.
The contents of this package may differ from that shown in the
figure above.
Sheath
This highly flexible, reinforced sheath is designed to resist kinking.
It incorporates a radiopaque marker located approximately 5 mm
proximal to the tip (Fig. 1). The Destination
is available in several distal segment shapes. The sheath has an
atraumatic tip which is hydrophilically coated. Coating length is
approximately 5 cm (50 mm) as measured from the distal end.
Dilator
The precise fit of the dilator in the sheath allows for simultaneous
motion of both dilator and sheath. The shape of the dilator
compliments the shape of the sheath. The radiopacity of the dilator
has been greatly enhanced to increase the visibility. The distal
segment of the dilator has been minimized to extend approximately
2 cm (20 mm) beyond the tip of the sheath.
Valve
Each Destination
either a Cross Cut Valve assembly (CCV) or a Y-shaped Tuohy-
Borst Valve (TBV). Both valve types are equipped with a three way
stopcock connected by a side tube.
Cross Cut Valve Assembly (CCV)
Y-Shaped Tuohy-Borst Valve (TBV)
®
Renal Guiding Sheath is designed to perform as
®
Renal Guiding Sheath is designed to be used for
Fig. 1
5 mm ± 1 mm
®
Renal Guiding Sheath comes packaged with
®
Renal Guiding Sheath
3