Installer Responsibilities - Modine MCV Série Manuel D'installation Et De Maintenance

START UP CHECKLIST & REPORT – Direct Fired MUA models MCV/MVV, DCV/DVV
INITITAL INSPECTION

Installer Responsibilities

1. Remote Panel: All interconnecting wires run from remote to unit
Temperature control interconnect wires to remote ran in:
Location:
*NOTE: If the Remote to Main Panel Interconnect Wiring is over 200' Long, Please Consult Factory
2. Gas supply run connected with proper gas pressure regulator and drip leg
3. Electrical supply properly installed to main panel, at voltage and amperage stated on unit nameplate
4. Duct connections made and sealed properly
5. Discharge diffuser installed secure, with blades tight and in the open position
6. All "shipped loose" items installed properly - filters, vibration isolators,
smoke detectors, relays, dampers, louvers, supply fan belts, roof curb, etc.
If No, reason(s): ____________________________________________________________________
7. All paint scratches have been properly touched-up
Comments:__________________________________________________________________________________________
Miscellaneous Items
1. Visible Physical Damage?
2. Installation Location:
3. Installation Type
4. Hardware Tight & Secure
5. Damper Linkages Secure
Comments:_________________________________________________________________________________________
Fan & Motor Sheaves
1. Fan & Motor Sheaves Secured Tightly to Shafts
2. V-Belts Aligned Properly
3. Fan Bearing Set screws Tight
4. Fan Hub Set Screws Tight
5. V-Belts Tensioned Properly
6. Fan Bearing Mounting Bolts Tight
7. Fan Motor: Manufacturer____________________________ HP________ FLA________ Frame Size _________
Comments:__________________________________________________________________________________________
Burner Inspection
1. Spark Igniter Secured Properly
2. Flame Rod Secured Properly
3. Ignition Wire Attached at Igniter & Transformer
4. Pilot Line Fittings Tight
5. Unions Tight and Secure
Comments:__________________________________________________________________________________________
2
42
Inside Wall Outside Wall
No Yes; If Yes, specify_____________________________________________
Outdoor Indoor
Roof Curb Platform
7 5 -
7-510.1
Shielded Cable Separate Conduit
Distance from Unit: ____ Feet (approx.)*
Post Suspended
5 2 0 .
Yes No
Yes No
Yes No
Yes No
Yes n/a
Yes No
Yes No
Other
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No