Installation And Connection - Bartscher 200270 Mode D'emploi

•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

CAUTION!
Installation and connection of the device may only be performed by certified
specialists.
•
Unpack the device and remove the packing material. Remove the entire
protective foil from the device.
•
Place the device on a flat, secure surface that can support its weight.
•
Never place the device on a flammable surface.
•
Do not place the device near an open flame, electric ovens, coal furnaces or other
sources of heat such as direct sunlight. High temperatures may have a negative
effect on cooling power and increase energy consumption.
•
Place the device so as to allow proper air circulation. Keep a minimum distance of
5 cm from the rear, 10 cm at the sides and 30 cm from the ceiling or shelves.
•
Never cover the device's ventilation ducts.
•
Do not place the device where high levels of ambient humidity occur. Such high
humidity may damage the device.
•
Only move the device by lifting it, to avoid damage to the adjustable legs and other
equipment.
•
Level the device by turning its legs.
- 25 -