Receiving Unit Diagnostics - AUtec E16SRXEU1 Manuel De L'utilisateur

9 RECEIVING UNIT DIAGNOSTICS

If the system "machine+radio remote control" does not start, check if the problem is caused
by the radio remote control or the machine. Therefore, before carrying out any verification
connect the cable control unit: if the machine does not start, the problem lies with the ma-
chine itself.
If, on the other hand, the machine only starts using the cable control panel, the problem lies
with the radio remote control. In this case, follow the diagnostics procedure of the transmit-
ting unit and then proceed as follows:
Is the POWER
signal light
switched on?
YES
Is the ENABLE
signal light
switched on?
NO
Carry out the
frequency change
procedure (see
transmitting unit
manual). Does the
machine start?
NO
Is the antenna
correctly
connected?
YES
(*) If the address keys (E16SCHEU_) have been replaced, do the following:
1. check that the transmitting unit is off and the receiving unit is powered
2. switch on the transmitting unit
3. press the START pushbutton without releasing it for at least 5 sec.
LIE&LQU4-01 - eng.fm
Are the terminal
NO
blocks correctly
connected?
YES
Remove power from
YES
the receiving unit.
Check fuses. Are
they intact?
YES
If the address keys
have been changed
it is necessary to re-
configure the receiv-
ing unit (*). Does the
machine start?
NO
Correctly connect
the antenna.
9 - Receiving unit diagnostics
Correctly connect
the terminal blocks
NO
and start the radio
remote control
Replace blown fus-
es. Connect to pow-
NO
er source and
switch on radio re-
mote control. Does
the machine start?
NO
NO
CALL THE AUTEC
SERVICE
Page 31