Introduction; General Description - AUtec E16SRXEU1 Manuel De L'utilisateur

2.1 GENERAL DESCRIPTION

Industrial radio remote controls are used to control
machines from a distance. Each industrial radio re-
mote control is made up of a portable transmitting
unit, from which the user can remotely control the
machine, and a receiving unit installed on board
the machine itself.
The transmitting unit uses radio frequencies to
transmit a coded message which contains a value
called address. Each receiving unit can only de-
code the messages coming from its own transmit-
ting unit with the same address.
This excludes the possibility of an interference ac-
tivating any system function. If the radio transmis-
sion is disturbed, incorrect or interrupted, the re-
ceiving unit autonomously stops the whole system.
Each radio remote control is in conformity with the R&TTE Directive 99/05/CE
Each radio remote control is also in conformity with the standards
given in the EC Declaration of Conformity that is enclosed with this manual.
Autec cannot be held responsible if the radio remote control is installed on applica-
tions that are different from those permitted:
Hoisting machines (construction cranes, bridge cranes, machines for material
handling in general,...).
Machines installed in areas where equipment with explosion-proof character-
istics is required.
Machines for moving, raising and transporting people.
It should be remembered that in some countries rules must be respected that
control:
- the use and/or possession of a radio remote control
- the use of working frequencies which have not yet been harmonised in Eu-
rope.
All the indications that must be observed can be found in the document "Lim-
itations & Authorisations", which is included in the product's documentation.
Page 18

2 INTRODUCTION

and its essential requirements.
PERMITTED USES
FORBIDDEN USES
LIMITATIONS & AUTHORISATIONS
2 - Introduction
Receiving unit
Transmitting
unit
LIE&LQU4-01 - eng.fm