Warnings For Maintenance; Routine Maintenance; Yearly Maintenance - AUtec E16SRXEU1 Manuel De L'utilisateur

Radiocommandes industrielles
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5 WARNINGS FOR MAINTENANCE

ALWAYS ENSURE THAT THE RECEIVING UNIT HAS BEEN DISCONNECTED
FROM THE POWER SOURCE BEFORE CARRYING OUT ANY MAINTENANCE
WORK.
All control and maintenance actions carried out on the radio remote control must be verified
and recorded by the person in charge of carrying out maintenance on the machine.
Routine maintenance carried out as described in this manual is fundamental
for using the radio remote control safely.
After each maintenance action, always make sure that commands sent by the
transmitting unit only activate the corresponding expected operations.

5.1 ROUTINE MAINTENANCE

The following instructions allow to maintain the radio remote control in perfect conditions,
guaranteeing it to function safely and correctly for a long period.
Special applications may need more specific routine maintenance actions to be carried out
at different periods.
These instructions do not in any case substitute the norms and laws that regulate work safe-
ty, nor do they limit the responsibility of the purchaser and user of the radio remote control.
All given instructions must be followed correctly each time the machine and the ra-
dio remote control are put into service.
Half yearly maintenance
1. make sure that all the relay contacts of the receiving unit operate correctly, and check
that the contact closes when the corresponding manoeuvre is enabled and opens when the
manoeuvre is disabled
2. check the correct correspondence between the commands that are sent and the ma-
noeuvres that are carried out
3. check that the contact for the SAFETY relay is open when no movement command has
been sent. This is safety critical maintenance.

Yearly maintenance

1. make sure that the units are intact in their structure
2. check that the wiring and the terminals are intact and connected
3. check that the identification plate is readable and not damaged
4. check the strips or other fixing systems and replace them if necessary.
Page 24
5 - Warnings for maintenance
LIE&LQU4-01 - eng.fm

Publicité

Table des Matières
loading

Produits Connexes pour AUtec E16SRXEU1

Ce manuel est également adapté pour:

E16srxeu2

Table des Matières