Programming; Programming The E16Srxeu_ Radio Receiving Module - AUtec E16SRXEU1 Manuel De L'utilisateur

The dip switches must be programmed when the receiving unit is not powered.
Programming must only be carried out by authorised personnel.
For the correct functioning, the group of 8 dip switches (excluding DIP 1) for
the radio modules E16STXEU_ (transmitting unit) and E16SRXEU_ (receiving
unit) must be set in the same way.

8.1 PROGRAMMING THE E16SRXEU_ RADIO RECEIVING MODULE

The group of eight dip switches locat-
ed on the radio module are used to
program some functions and set the
working frequency.
The programming set in the other
group of four dip switches must never
be modified.
DIP MODULE STATE
*
E16SRXEU_
1
**
E16SRXEU_
2
E16SRXEU1
3
E16SRXEU2
3-7 E16SRXEU_ ON/OFF
8 E16SRXEU_
* For the MK10, MK12 and MJ transmitting units the dip switch must be at ON.
** For the MK12 transmitting unit the dip switch must be at ON.
Page 30

8 PROGRAMMING

Group of 8 dip switches
Stop after 0.35 sec with invalid radio signal
ON
Stop after 1 sec with invalid radio signal
OFF
Deactivation of low battery warning from horn on machine
ON
Activation of low battery warning from horn on machine
OFF
If DIP 8 is OFF automatic scan of the frequencies in the
ON
band 433.050 - 434.040 MHz
If DIP 8 is OFF automatic scan of the frequencies in the
OFF
band 434.050 - 434.790 MHz
DO NOT USE
ON
If DIP 8 is OFF automatic scan of the frequencies in the
OFF
band 869.700 - 870.000 MHz
If DIP 8 is ON see "Appendix: Frequency Table"
Manual selection mode of the frequencies using DIP 3 -
ON
DIP 7 (refer to "Appendix: Frequency Table")
Automatic scan mode of the frequencies in the band
OFF
selected by DIP 3 (DIP 4 - DIP 7 indifferent)
8 - Programming
Group of 4 dip
Group of 8
switches
dip switches
FUNCTION
LIE&LQU4-01 - eng.fm