Makita DFT041R Manuel D'instruction page 8

Status of the LED indicator/beeper
LED indicator
Lights up in
A long beep
yellow.
Blinks in red
and yellow A long beep
alternatively.
Blinks in red
A series of short
and blue
beeps
alternatively.
Note: These values can be changed on PC (except
for DFT041R). Refer to SRCV02 USER MANUAL for
details.
Function
Beeper
Result of torque
judgment: NOK
(Low)
Warning against
insufficient
fastening
Double-hitting
detection
Angle judge NOK
Rundown NOK
Torque impossible
monitoring
Disconnection
(when using
receiver RCV02)
Radio
communication
failure
Status
This function works
when the tool has
reached below the
fastening torquer
ange preset on PC.
(Note)
Fastening is
imcomplete when
switch trigger of tool
is released before
clutch activation.
This function works
when a screw is
refastened after
fastening.
This function works
when a screw is not
fastened within the
angle range preset
on PC (Note).
This function works
when a fastening is
finished before it
reaches the preset
angle range. (Note)
This function works
when torque monitoring
is cannot be carried out.
Radio communication
not yet established
This function works
when there is radio
communication failure.
8 ENGLISH
Action to be taken
Finish necessary
connection or
remove a battery
cartridge to escape.
Take it to a Makita
Authorized Service
centers.