Operation And Maintenance; Tips And Recommendations For Use - Simu T3.5DC ESP HZ Notice Originale

CANCELLING THE PROGRAMMING
11
During the operations in this section (§11), do not work on several motors at the same time.
11.1
12V - 2.2Ah
11.1- Disconnect the solar panel from the T3.5DC ESP HZ motor
11.2- Disconnect the battery from the T3.5DC ESP HZ motor for 2 seconds.
11.3- Connect the battery to the motor for 7 seconds.
11.4- Disconnect the battery from the motor for 2 seconds.
11.5- Connect the battery to the motor . If the motor is on the end limit position (up or down), the motor will run
briefly in one direction and then in the other, otherwise, the motor runs for 5 seconds in random direction.
The motor is now in the "cancelling mode". Go to section 11.6.
11.6- Then, confirm the cancelling of the concerned motor from the individual control :
- Press the PROG button of the transmitter
more than 7 seconds. Maintain the
pressure until the motor will first run for 0,5
second in one direction and then in the other,
and a few second later, it will run again in both
direction.
The memory of the motor is now completely deleted. You can connect the solar panel, and then proceed
to the complete programming (§2).

OPERATION AND MAINTENANCE

12
- This drive is maintenance-free.
- Press the ▲ button on the control point to raise the motorised product.
- Press the ▼ button on the control point to lower the motorised product.
- If the motorised product is moving, briefly press the "Stop" button, the motorised product stop automatically.
- The motorised product is then stopped, briefly press the "Stop" button, the motorised product moves to the
programmed intermediate position. (To modify or delete an intermediate position, see the section §6).

Tips and recommendations for use :

PROBLEMS
The motorised
product is not
operational.
If the motorised product still does not work, contact a drive and home automation professional.
We care about our environment. Do not dispose of the appliance with usual household waste. Give it
to an approved collection point for recycling.
Please separate storage cells and batteries from other types of waste and recycle them via the local
collection facility.
SIMU SAS, 70100 ARC-LÈS-GRAY as manufacturer hereby declares that the drive covered by these instructions and used as intended according to these instructions
is in compliance with the essential requirements of the applicable European Directives and in particular of the Machinery Directive 2006/42/EC, and the Radio Directive
2014/53/EU. The full text of the EU declaration of conformity is available at www.simu.com. Bruno STRAGLIATI, Executive Officer, ARC-LÈS-GRAY, 01/2020.
EN
8/8
11.2
2s
12V - 2.2Ah
POSSIBLES CAUSES
The battery of the control point is low.
The battery of the system is low.
External radio equipment is interfering with the radio
reception (e.g. Hi-Fi radio headphones).
11.3 11.4
7s
12V - 2.2Ah
11.6
1
PROG > 7 s
11.5
>>>
2s
12V - 2.2Ah 12V - 2.2Ah
>>
2 s
SOLUTIONS
Check the battery and replace
is as required.
Recharge the battery (see
intruction 5136806/5144624).
Turn off all radio equipment
nearby.
5 s
7 s