Simu T3.5DC ESP HZ Notice Originale page 14

« CLOSING FORCE » FUNCTION
7
This function allows the closing force of the awning's box to be increased or decreased to 3 levels (high/
medium/low).
Contact the awning's manufacturer before using these functions to check the compatibility of your
systems. For safety reasons, this function can only be accessed via the individual control point in
3 situations:
• After the settings confirmation and before programming the first control point.
• After programming the first control and during the next 4 cycles.
• After a single power outage and during the next 4 cycles.
1
+
1 - Position the motor to the halfway position using the DOWN or UP button. Press the "STOP" button to
stop the awning.
2 - To activate closing force function press twice successively:
- For half a second press simultaneously STOP and UP buttons, without the motor rotating.
- For more than 5 seconds press simultaneously STOP and UP buttons. The motor will run for 0.5
second in one direction, then in the other direction.
The motor is now in programming mode for only 10 seconds, the motor is factory set at the medium level.
- To increase the closing force, press the UP button until the awning makes a slow movement, the box
3
awning's closing force has moved up a level.
- To decrease the closing force, press the DOWN button until the store makes a slow movement, the box
awning's closing force has moved down a level.
4 - Confirm the new setting by pressing 2 seconds the STOP button. The motor will run for 0.5 second in
one direction, then in the other direction. The new setting is memorized, the operation is completed.
« BACK IMPULSE » FUNCTION
8
This function back tensions the fabric after an opening order. This function will only be activated once the
installation of the motor is completed.
To activate the function set the angle between 11 and 180° (to disable the Back impulse, set the angle
to 0°):
1
1- Move the motor to the DOWN end limit previously set in section 2.3 with the DOWN button.
2- Press simultaneously for 5 seconds the UP and STOP buttons. The motor will run for 0.5 second in one
direction, then in the other direction.
3- Adjust the angle of back impulse function (between 11 and 180°) with the UP and DOWN buttons.
4- Confirm the setting by pressing 2 seconds the STOP button. The motor will run for 0.5 second in one
direction, then in the other direction. The operation is completed.
The «back impulse» function is disable in the factory mode.
EN
6/8
2
+
0,5 s 5 s
2
5 s
3
3 4
Between
11 and 180°
4
2 s
2 s