Simu T3.5DC ESP HZ Notice Originale page 11

INSTALLATION
1
Instructions which must be followed by the drive and home automation professional installing the
drive:
- Methods of wiring are given by national standards or IEC 60364 standard.
- Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve. Secure
the cables to prevent any contact with moving parts. The connectors must be protected against rain, inside
the awning box.
- The cable for the motor cannot be removed. If it is damaged, return the drive to the After-Sales department.
Recommendations: Keep a minimum distance of 20 cm between two T3.5DC ESP HZ motors. Keep a
minimum distance of 30 cm between T3.5DC ESP HZ motors and Hz transmitters. A radio appliance using the
same frequency (433,42 MHz) may deteriorate our product's performance (ex. : hi-fi radio headphones). Use
an antistatic fabric.
Refer to instruction 5117585/5139459 for solar panel installation.
Refer to instruction 5136806/5144624 for battery installation. Recharge the battery before use
with the charger ref. 9020638.
Drilling of the tube:
C
D
29
Ø38,2
Mounting:
PLASTITE FXS N7 \ 7X12 ZING
(5005970)
END LIMIT ADJUSTMENT
2
If the installation includes several motors, only one motor should to
be powered during this programming procedure 2.1. It will eliminate
interferences with the other motors during the procedure.
2.1- Learning mode:
1- Connect the 12V battery to the motor.
2- Then, connect the 12V solar panel to the motor. Go to next step.
3- Press simultaneously on the "UP" and "DOWN" buttons of the
Hz transmitter. The motor turns 0.5 second in one direction, then
in the other.
This transmitter now commands the motor in unstable mode. Go to
step 2.2.
2.2- Checking the rotation direction:
Press the UP button of the transmitter :
a- If the motorized tube runs in the Up direction, move to next stage 2.3.
b- If the motorized tube runs in the Down
direction, reverse the rotation direction
by pressing the STOP button for at
least 3 seconds. The motor will run
for 0.5 second in one direction, then in
the other direction. Move to the stage
2.3.
A
ØB
L2
L1
IP44
1,2
mm
Ø min.
03/23 • 06/18 • 10/12
4
2
1
>>
OK
a
>>
b
>>
3 s
A ØB C
37 433 4.2 8
Ø4 x 10 / 120°
STEEL
3
3
>>
1
>>
§ 2.3
>>
D L1 L2
5.5 487 470
1
2
>>
§ 2.3
EN
3/8