Arai Helmet QV-PRO Instructions D'utilisation page 14

①
14
TO REMOVE/REPLACE BREATH DEFLECTOR
To remove, grasp either side of the edge and pull upward and toward to
②
opposite end
To install, first insert the center of the deflector in the receiving slot and then
push in the sides working from the center outwards
NOTE:
spacer (optional) in this place as it actually acts as an anti mist ducting device.
TO REMOVE/REPLACE CHIN COVER
WARNING: DO NOT pull chin cover. Read instructions completely
before attempting removal. Failure to do so may result in damage to
the cover and/or helmet.
To remove, begin with the helmet upside down on a table or in your lap, with
the shield facing away from you.
2
Grasp the chin cover as shown and slide/rotate the entire cover to either
direction by approximately 2cm (3/4"). Lift the cover out.
1
To replace, begin with the helmet upside down on a table or in your lap, with
the shield facing away from you.
Pull chin spoiler down to its fully open position.
English
①
.
If you do not use the deflector we recommend you to install Anti-mist
②
.